To identify if your hydraulic fittings are JIC (Joint Industry Council), check the fitting's flare angle; JIC fittings have a 37-degree flare. Additionally, JIC fittings are typically characterized by their straight threads and are often labeled with the SAE J514 standard. See full answer »

To identify JIC fittings, first measure the outer diameter of the male thread or the inner diameter of the female thread using a caliper. Then, compare these measurements to a JIC thread size chart to determine the correct size, ensuring the fitting has a 37-degree flare angle, characteristic of JIC fittings. See full answer »

The JIC (Joint Industry Council) fitting is equivalent to the AN (Army-Navy) fitting in terms of thread size and pitch, but they are not identical. Both types use a 37-degree flare to create a metal-to-metal seal, making them compatible for many applications, though AN fittings are typically made to stricter military specifications. See full answer »

JIC stands for Joint Industry Council. In hose fittings, JIC refers to a type of fitting that uses a 37-degree flare seating surface to create a metal-to-metal seal, commonly used in hydraulic systems for its reliability and reusability. See full answer »

To determine the size of your JIC fitting, you need to measure the outside diameter of the male thread or the inside diameter of the female thread. Once you have this measurement, refer to a JIC fitting size chart to match the measurement with the corresponding fitting size. JIC fittings are typically measured in 1/16-inch increments, so knowing the precise diameter is crucial for an accurate identification. See full answer »

In hydraulics, "JIC See full answer »

JIC fittings, or Joint Industry Council fittings, seal through a metal-to-metal connection. They feature a 37-degree flare on the fitting end, which mates with a corresponding flare on the tube or hose, creating a tight, leak-proof seal when tightened. This design provides a reliable and reusable connection commonly used in hydraulic systems. See full answer »

A female JIC (Joint Industry Council) nut is typically sized according to the dash size system, which corresponds to the outer diameter of the tube or fitting it is intended to mate with. These sizes are usually expressed in sixteenths of an inch, ranging from -2 (1/8 inch) to -32 (2 inches). To determine the specific size needed, you would match the JIC nut size to the corresponding tube or fitting size it is meant to connect. See full answer »