To identify the thread on hydraulic hose fittings, you can use a thread gauge to measure the pitch and diameter, and compare these measurements to a thread identification chart. Additionally, examining the fitting's design, such as whether it has straight or tapered threads, can help determine the thread type and standard (e.g., NPT, BSP, JIC). See full answer »

The most common JIC fitting is the JIC 37-degree flare fitting, often referred to as the JIC 37° fitting. This type of fitting is widely used in hydraulic systems due to its reliable, leak-proof metal-to-metal seal and compatibility with various tubing and hose materials. See full answer »

The numbers on a hydraulic hose indicate the size of the hose. They usually refer to the inside diameter, outside diameter and the pressure rating of the hose. You can find this information on the website of discounthydraulichose the section "Hydraulic Hose", See full answer »

To determine the JIC fitting size, measure the outside diameter (OD) of the male thread or the inside diameter (ID) of the female thread using calipers. Then, match these measurements to a JIC size chart to identify the corresponding fitting size. See full answer »

Certainly! "JIC" stands for Joint Industry council. See full answer »

To identify JIC (Joint Industry Council) hydraulic fittings, look for a 37-degree flare seating surface on the male fitting and a corresponding 37-degree flare on the female fitting. Additionally, JIC fittings typically follow SAE J514 standards, and you can verify the thread size and pitch using a thread gauge or caliper to ensure compatibility. See full answer »

JIC hydraulic fittings are measured by their outer diameter (OD) and thread pitch. The measurement is typically taken in inches, and the thread pitch is specified in threads per inch (TPI) to ensure a proper fit and seal in hydraulic systems. See full answer »

JIC (Joint Industry Council) and NPT (National Pipe Taper) are two different types of fittings used in fluid systems. JIC fittings have a 37-degree flare seating surface and are typically used for high-pressure applications, providing a metal-to-metal seal. NPT fittings have a tapered thread that seals by wedging the threads together, often requiring a sealant like Teflon tape, and are commonly used in low to medium pressure applications. See full answer »

Number 6 JIC (Joint Industry Council) refers to a fitting size with a 3/8-inch outer diameter for the tube. JIC fittings are commonly used in hydraulic systems and feature a 37-degree flare seating surface to ensure a tight, leak-proof seal. See full answer »

The standard for JIC (Joint Industry Council) fittings is defined by the SAE J514 specification. These fittings have a 37-degree flare seating surface, commonly used in hydraulic applications for providing a reliable, leak-proof seal. See full answer »