JIC stands for Joint Industry Council, which developed the standards for these fittings. JIC fittings are commonly used in hydraulic systems due to their high-pressure capabilities and reliable sealing, characterized by a 37-degree flare seating surface. See full answer »

To identify JIC fittings, first measure the outer diameter of the male thread or the inner diameter of the female thread using a caliper. Then, compare these measurements to a JIC thread size chart to determine the correct size, ensuring the fitting has a 37-degree flare angle, characteristic of JIC fittings. See full answer »

Hydraulic hose is typically measured by its Inner Diameter (ID). This measurement is important because it determines the flow velocity of the hydraulic fluid within the hose. Source: 1. "Hydraulic Hose 101: Fast Facts" - https://www.parker.com/literature/Hos.... (See under "Hose Size Selection Nomograph" section) 2. "Hydraulic hose sizing" - https://www.pirtekusa.com/technical-i... (See under "Hose Bore size" section). See full answer »

The ID of a hydraulic hose refers to its "inside diameter." It is a critical measurement that indicates the size of the pipe. This measurement directly correlates to the rate of fluid flow within the hose, the pressure it can withstand, and its fitting compatibility. Reference: 1. "Hydraulic Hose 101: Fast Facts" (https://www.hoseassemblytips.com/hydr...). You can see this information in the section titled "Size." 2. "How to Identify Fluid Ports and Connectors" (https://www.hydraulicsdirect.com/Flui...). The information can be found in the paragraph under the subheading "How to Measure Threads." See full answer »

To identify JIC (Joint Industry Council) hydraulic fittings, look for a 37-degree flare seating surface on the male fitting and a corresponding 37-degree flare on the female fitting. Additionally, JIC fittings typically follow SAE J514 standards, and you can verify the thread size and pitch using a thread gauge or caliper to ensure compatibility. See full answer »

A 10 JIC hose refers to a hose with a fitting size of or 5/8 inches. JIC (Joint Industry Council) fittings are a type of flare fitting used in high pressure applications and are measured by their thread size. Source: https://www.hoseandfittingsetc.com/ou... You can find the information in the "JIC 37 Flare (SAE J514)" section of the thread chart. Source: https://wojnarowicz.com.pl/docs/Metod... You can find the information on page 16, under the "JIC 37° Flare (SAE J514)" section. See full answer »